Florestone Products Co. -Model 80/81/82/83 Terrazzo Mop Receptors

DOWNLOADS

Furnish and install mop receptor as manufactured by Florestone Products Co. Shoulder shall be not less than 4" high inside and not less than 1¾" wide. (For high wall model specify: “Not less then 9" high inside and not less than 1¾" wide”).


Category: floor sinks | lavatories | plumbing fixtures...

MasterFormat: Plumbing Fixtures | Commercial Plumbing Fixtures | Commercial Lavatories and Sinks...



Florestone Products Co.
2851 Falcon Drive
Madera, CA 93637
Tel: (800) 446-8827
Fax: (559) 661-2070

info@florestone.com

http://www.florestone.com/

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Model 80/81/82/83 Terrazzo Mop Receptors

Furnish and install mop receptor as manufactured by Florestone Products Co. Shoulder shall be not less than 4" high inside and not less than 1¾" wide. (For high wall model specify: “Not less then 9" high inside and not less than 1¾" wide”). Galvanized, bonderized steel flange will extend at least one inch above shoulder on one, two or three sides for installation against stud wall (specify choice). Stainless steel protective cap to be cast integral on all four exposed sides. Drain body shall be brass, cast integral and shall provide for a non-caulked connection (lead caulked optional) not less than one inch deep to a two or three inch pipe (specify 2" or 3"). Mop sinks with 3" drains are supplied with a rubber seal for use on ABS, PVC or steel pipe. Receptor shall be manufactured of tan and white marble chips cast in white portland cement to produce a compressive strength of not less than 3000 PSI, seven days after casting. Terrazzo surface shall be ground and polished with all air holes and/or pits to be grouted and excess removed and sealed to resist stains and moisture. Receptor will be reinforced with 16 gauge wire.


Note:

Specify 6" or 12" height.
Specify 2" or 3" drain size (3" standard).
Specify Model Number and size.
Specify Right Hand or Left Hand where applicable.

Dimensions may vary ± ¼ inch. Please check unit before installation.


Note: Terrazzo is not designed to be used with anything that is over 130 degrees Fahrenheit.

Shown: Model 81


See More


Specifications

ABHT.CDEWT
24"24"6"12"12"12"225
32”32"6"16"16"16"320
36”24"6"18"18"12"295
36”36"6"18"18"18"385
24”24"12"12"12"12"355
32”32"12"16"16"16"488
36”24"12"18"18"12”430
36”36"12"18"18"18"525
Sweetsstakes