Polyurethane - 1 Component Pedestrian Traffic Coatings - Sikalastic®-710 NP Base

Single component, elastomeric, crack-bridging, primerless, waterproofing base coat

Sikalastic®-710 NP Base is a single component, aromatic, moisture cured, elastomeric polyurethane coating intended for use as the waterproofing base coat under polyurethane or epoxy wearing surfaces for pedestrian and vehicular traffic bearing applications, and as the waterproofing base coat under a separate wearing course such as concrete, and tile in a setting bed. Sikalastic®-710 NP Base can be a direct replacement for Sikalastic® 710 in all applications.

• Excellent crack-bridging properties and flexibility, even at low temperatures
• Primer not required for typical applications
• Resistant to water and deicing salts
• Alkaline resistant

Usage

• Multi-story parking garages
• Parking decks and ramps
• Foot bridges and walkways
• Mechanical rooms
• Stadiums and arenas
• Plaza and rooftop decks
• Balconies
• Sikalastic®-710 NP Base can be used in the following systems:
  • Sikalastic®-710 NP Base/ Sikalastic®-715 Top
  • Sikalastic®-710 NP Base/Sikalastic®-715 Textured
  • Sikalastic®-710 NP Base/Sikalastic®-736 Textured

Advantages

• Excellent crack-bridging properties and flexibility, even at low temperatures
• Primer not required for typical applications
• Resistant to water and deicing salts
• Alkaline resistant

Packaging

5 gal. pails, 50 gal. (net) drums

Color

Medium Gray

Product Details

Product Information

1 year in original, unopened containers

Store dry at 40-95 °F (4-35 °C).
Condition material to 65-85 °F (18-30 °C) before using.

6500 ± 3000 cps

Technical Information

Resistant to de-icing salts.

Application

Consumption

50 ft²/gal. at 32 wet mils (23 dry mils).

NOTE: Coverage rates provided are optimal and are not guaranteed. Coverage rates will vary depending on temperature, surface roughness and porosity, aggregate selection and embedment, and application technique.

Application Steps

Thoroughly mix coating using a mechanical mixer (Jiffy) at slow speed until a homogenous mixture and uniform color is obtained (typically 1 minute). Use care not to allow the entrapment of air into the mixture.

Apply at the recommended coverage rate (see Sikalastic® 710/715/735 AL System Guide) using a notched squeegee or trowel, and backroll using a phenolic resin core roller. Extend base coat over entire area including previously detailed cracks and joints. Allow coating to cure a minimum of 16 hours at 70 °F and 50 % RH or until tack fee before top coating. Allow coating to cure for a minimum of 72 hours before installing separate concrete pavement or tile wear course.

Removal

Remove liquid coating immediately with dry cloth. Once cured, coating can only be removed by mechanical means.

See More

See Less