Patterns & Textures - Scofield® Liquid Release BG

Bubblegum Scented Release

SCOFIELD® Liquid Release BG is a low-cost bubble gum scented release and bond breaker for use in the concrete stamping process. Application of SCOFIELD® Liquid Release BG to the concrete surface and stamps prior to stamping will prevent the transfer of the wet paste to the stamping mat. It may also be applied to tools to prevent them from marring patterns in fresh concrete and may be used when stamping or texturing cementitious overlays. SCOFIELD® Liquid Release BG will not damage integrally colored concrete and is suitable for use with most color hardeners. It will evaporate completely, leaving no residue, and will not interfere with the application of solvent-borne sealers. SCOFIELD® Liquid Release BG is not intended for use as a bond breaker for tilt-up construction.

• Pleasant scent
• Economical
• Easy to use
• Easy clean up of stamp

Usage

Apply over fresh concrete or overlays that will be imprinted with stamping tools.

Advantages

• Pleasant scent
• Economical
• Easy to use
• Easy clean up of stamp

Packaging

5-gallon (18.9 L) pails.

Product Details

Product Information

Shelf Life

1 year in original, unopened container.

Storage Conditions

Do not store at temperatures below 32 degrees F (0 degrees C).

Application

Consumption

Coverage

Concrete Surface: 200 ft²per gallon. Stamps and Tools: 400 ft²per gallon.

Application Steps

APPLICATION

SCOFIELD® Liquid Release BG should be applied to the concrete surface and the clean imprinting tool with a pump up sprayer, immediately prior to imprinting. An even, light application to both surfaces should be sufficient to prevent the transfer of paste. Since the material evaporates, it is necessary to minimize the time between application of the release material and the imprinting process. Mats and tools will need to be periodically resprayed. The evaporation rate of SCOFIELD® Liquid Release BG is affected by wind, humidity, and temperature. Avoid applying excessive amounts of the material, as this may cause defects in the concrete surface. If excess material is applied, allow to evaporate. Product leaves no residue.

See More

See Less