Control Joints - Sikadur®-58 CJR

Semi-flexible Epoxy Control Joint Resin

Sikadur®-58 CJR is a 2-component, self-leveling, 100 % solids, flexible, control joint resin sealer and adhesive.

• Remains semi-flexible. Does not age-harden
• Prevents deterioration of joint edges
• Excellent adhesive properties
• Ideal for use with plural injection type systems
• Shock absorbent and durable. Withstands wheel traffic and heavy loads
• Conforms to ACI 302.1R (4.10 - Joint Materials)
• Use as a tamper resistant sealant

Usage

• Horizontal, non-moving, interior, horizontal saw cut, preformed control and construction joints
• Facilities such as warehouses and industrial plants, where such joints are subject to load-bearing conditions involving wear and impact
• Repairing interior concrete slabs that have experienced random cracking due to shrinkage / As a semiflexible adhesive

Advantages

• Remains semi-flexible. Does not age-harden
• Prevents deterioration of joint edges
• Excellent adhesive properties
• Ideal for use with plural injection type systems
• Shock absorbent and durable. Withstands wheel traffic and heavy loads
• Conforms to ACI 302.1R (4.10 - Joint Materials)
• Use as a tamper resistant sealant

Packaging

10 gal. kits (2 x 5 gal. A + B)

Color

Concrete Gray

Product Details

Product Information

24 months in original, unopened containers

Store dry at 40-95 °F (4-35 °C).

Condition material at 70-80 °F (21-27 °F) before using

Application

Application Information

Component ‘A’ : Component ‘B’ = 1:1 by volume.

25 minutes, 8 fl. oz. (250 g)

Shave time: ~24 Hours

2.5- 3 hours

Application Steps

Substrate must be clean and sound. It may be dry or damp, but must be free of standing water. Remove dust, laitance, grease, curing compounds, bond inhibiting impregnations, waxes and any other contaminants. Concrete should be cleaned and prepared to achieve a laitance and contaminant free, open textured surface by blast cleaning or equivalent mechanical means. The most common method utilizes a dustless, diamond blade saw. Climate controlled rooms should be stabilized at least 14 days before application of Sikadur®-58 CJR. Priming is not required. The application of stain preventing film or waxing with Dial bar soap on surfaces adjacent to control joints may be used to prevent the occurrence of staining from joint filler overflow. A thin layer of clean, dry sand may be used to prevent the flow of joint filler into stress cracks that occur at the bottom of control joints. Do not use a compressible backer rod to stop the flow of Sikadur®-58 CJR unless the joint depth exceeds 2 in. (60 mm). Joint width should be between 1/8 in. (3.2 mm) and 3/8 in. (9.5 mm).

Pre-mix each component thoroughly before using (usually 1-3 minutes - color must be consistent). If applying without a mechanical pump, proportion equal parts by volume of Component A and Component B into clean pail. Mix thoroughly for 3 minutes with a low-speed (400-600 rpm) drill using a Sika paddle until uniform in color. Mix only quantity that can be applied within its pot life.

See More

See Less