Infrared Dynamics -Sunpak S34-TSH Outdoor Infrared Patio Heaters

DOWNLOADS

The Sunpak S34-TSH (Two Stage Hardwired) is all hardwired for convenience with no remote control to lose or batteries to replace. This heater is easily to control with a duplex switch. Sunpak heaters are CSA design-certified as an unvented infrared heater for outdoor use.


Category: CSA design certified heaters | fuel fired heaters | gas fired unit heaters...

MasterFormat: Residential Equipment | Gas-Fired Radiant Heaters | Fuel-Fired Unit Heaters...



Infrared Dynamics
3830 Prospect Ave
Yorba Linda, CA 92886
Tel: (888) 317-5255
Fax: (714) 572-6093

rcowan@infradyne.com

https://infradyne.com/

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Sunpak S34-TSH Outdoor Infrared Patio Heaters

The Sunpak S34-TSH (Two Stage Hardwired) is all hardwired for convenience with no remote control to lose or batteries to replace. This heater is easily to control with a duplex switch. Sunpak heaters are CSA design-certified as an unvented infrared heater for outdoor use. All units are equipped with spark ignition and 100% shutoff for safety, economy and convenience. Select the optional face trim in Black, Bronze or Stainless Steel to give the S34-TSH a streamline appearance.

  • Slim Profile (8″ H x 8″ W x 47-1/2″
  • Hi/ Lo Control (25K to 34K Btu/Hr)
  • Natural or Propane Gas
  • Angle Mounting - Zero to 30 Degree
  • Ideal for Wind Protected Area
  • Rain Protected
  • 24 VAC Controls (24 VAC power Required)
  • Optional Face Trims (Stainless steel, Black or Bronze)
  • Optional Mounting Kit (Stainless steel or Black)
  • Optional 24 VAC Transformer
  • Weight 40 lbs


See More


Specifications

Heater Installation

Sunpak Heaters are intended to be installed by qualified personnel specifically trained and experienced in the installation of this type of heater and related system components. Some states or provinces require installation and service personnel to be licensed. If you state or province is such, be sure your contractor bears the appropriate license. Persons not qualified shall not attempt to install or repair this heater.

For Outdoor Use Only

Sunpak heaters are designed for outside use only. They are not for use in residential dwelling or other confined areas. Semi-enclosed patio are permissible provided they have adequate permanent openings around the patio periphery and meet the requirements for outdoors as defined in the installation instructions.

Clearance from Combustible Materials

Sunpak heaters all require a minimum distance from walls and ceilings. This is an important consideration for your design. Refer to instructions for details For S34-TSH use S34 dimension as indicated below.

Use S34 Clearances for S34-TSH
Comfort Level

Typically you can expect the radiant heat to spread about 10 feet in each direction increasing the comfort level 5-10 deg F. outdoors.

Ventilation

Sunpak Heaters require adequate combustion air and ventilation to operate safely and efficiently. This requires openings above and below the level of the heater. Refer to the heater instructions for more detail.

Electrical Requirements

Sunpak® Heaters come with a 24 VAC spark ignition system which includes flame monitoring through flame rectification. All Sunpak S34-TSH Heaters require an external 24 VAC Transformer. Transformer should never be placed inside the heater.

Gas Pressure

Sunpak® Heaters require a minimum inlet pressure of 6″ water column for natural gas and 11″ water column for propane gas. Gas pressure should never exceed 1/2 PSI or 14″ water column. For gas pressures exceeding 1/2 PSI a high-pressure regulator is required before the gas enters the heater.

Agency Certification

Sunpak heaters are design certified by the CSA under the ANSI Z83.19 standard

Heater Gas Conversion

The factory does not support converting heaters to different gases. Each heater has been setup and tested for a specific gas type. Please make sure you select the correct gas type, Natural or Propane gas, before making your purchase.