Bostik -GreenForce™ Advanced Tri-Linking™ Adhesive and Moisture Control Membrane


Bostik GreenForce™ is a high performance hardwood flooring adhesive and moisture control membrane all in one.

Category: flooring adhesives | membranes | underlayments...

MasterFormat: Common Work Results for Wood, Plastics, and Composites | Adhesives* | Flooring Installation Products*...

11320 W. Watertown Plank Road
Wauwatosa, WI 53226
Tel: (800) 726-7845

Find a rep/distributor

Request More Info


Related Products


GreenForce™ Advanced Tri-Linking™ Adhesive and Moisture Control Membrane

Bostik GreenForce™ is a high performance hardwood flooring adhesive and moisture control membrane all in one. With Bostik’s breakthrough AXIOS® Tri-Linking™ Polymer Technology, GreenForce™ maintains the superior long term durability and moisture protection properties of high-end urethane hardwood floor adhesive, but it is easier to spread and clean off of prefinished flooring, even after full cure.

GreenForce™ is a Flooring Adhesive and Moisture Control Membrane in One

GreenForce™ hardwood flooring adhesive has extremely low moisture vapor permeability and is not adversely affected by moisture. As a result, costly and time consuming concrete moisture testing is not required when the slab is properly prepared, dry to the touch and fully cured.

Use GreenForce™ in Applications that Require an Anti-fracture, Antimicrobial Hardwood Flooring Adhesive

The elastomeric characteristics of GreenForce™ establish an anti-fracture membrane that can bridge cracks up to 1/8" (3mm), which can occur in the substrate prior to or after installation. This superior elasticity allows GreenForce™ adhesive to move with the floor as it expands and contracts with changes in humidity and temperature over its lifetime.

GreenForce™ also comes with Bostik’s BLOCKADE® antimicrobial protection, which inhibits the growth of bacteria, mold or mildew on the surface of the cured membrane. The cured membrane resists stains caused by mold.

GreenForce™ adheres to all the most common substrates used in hardwood flooring installation

Bostik GreenForce™ high performance adhesive may be used with all engineered hardwood flooring, solid hardwood flooring, bamboo, cork, and parquet. GreenForce™ has no restrictions on board width or length. It may be used over all properly prepared substrates common to hardwood flooring installations including concrete, plywood, well-bonded vinyl/VCT and ceramic tile, cement backer board, gypsum underlayments (dry, above grade), cement patch/underlayments, radiant-heat flooring, and properly prepared terrazzo. GreenForce™ adhesive can also be used to install plywood as described, as well as ceramic tile, marble, and stone inlays for light commercial and/or residential applications.

Key Features
  • 2 in 1: flooring adhesive and moisture vapor control
  • Easy clean before & after cure
  • Unlimited moisture vapor protection
  • Superior bond strength & green grab
  • Anti-fracture performance; can bridge cracks up to ⅛ inch
  • Zero VOC content (as calculated per SCAQMD Rule 1168)
  • No restriction on board length or width
  • Blockade® Antimicrobial protection
  • Isocyanate-free formula

See More


Where to UseSubstratesMaterials
ResidentialConcreteSolid hardwood flooring
Offices and light commercialPlywoodEngineered hardwood flooring
Heavy commercialOSBBamboo flooring
OfficesWell-bonded vinylCork flooring
HospitalTerrazzoParquet flooring
Ceramic tilePlywood
Cement backer boardCeramic tile, marble, and stone inlays (in residential or light commercial only)
Gypsum underlayments (dry, above-grade)
Cement patch/underlayments