Wooster Products, Inc. -Abrasive Cast Nosings & Misc

DOWNLOADS

Wooster’s quality cast nosings contain an even distribution of abrasive grit integrally cast into the surface for anti-slip protection and long wear. Width and length to order. Available in ALUMOGRIT® (abrasive cast aluminum)


Category: aluminum nosings | aluminum stair nosings | cast aluminum stair treads...

MasterFormat: Metal Stair Treads and Nosings | Metal Stair Nosings | Metal Castings



Wooster Products, Inc.
P.O. Box 6005
1000 Spruce Street
Wooster, OH 44691
Tel: (800) 321-4936
Fax: (330) 262-4151

sales@wooster-products.com

http://www.woosterproducts.com/

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Abrasive Cast Nosings & Misc

Wooster’s quality cast nosings contain an even distribution of abrasive grit integrally cast into the surface for anti-slip protection and long wear. Width and length to order. Available in ALUMOGRIT® (abrasive cast aluminum) and in FERROGRIT® (abrasive cast iron).

Specify abrasive castings for:
Maximum Durability in Rough Use
Indoor or Outdoor Use
Resistance to Unusually Corrosive Environments
Anti-Slip Safety Properties
Ready to Install Convenience
New Construction or Existing Buildings

Surface: Abrasive cross-hatch is standard and will be furnished unless plain or fluted surface is specified. (Cross-hatch pattern may not match up on sections being butted together.)
Fasteners: Concealed integral anchors or steel wing anchors, nuts and bolts for wet concrete. Or drilled and countersunk holes for other fasteners.
Length: Maximum length is 8’6″ in ALUMOGRIT® (abrasive cast aluminum) and 6’0″ in FERROGRIT® (abrasive cast iron).
Width: Standard widths are 3″, 4″ and 6″. Standard measurements are from top of the leading edge.


See More


Specifications

FOR POURED CONCRETE
Type 101 - Nose 1/4″.
Chief use: as nosings in concrete stairs.
Type 116 - Nose 1″.
Chief use: as nosings in concrete stairs where deeper lip is desirable
FOR EXISTING STAIR REPAIR
Type 116A - Nose 1″ standard.
Chief use: on top of existing steps for repair and modernization.
CONCRETE CURB BARS
Type 150 - 1 1/2″ X 1 1/2″ X 3/8″
Type 250 - 2 1/2″ X 2 1/2″ X 1/2″
Maximum length on 250 Ferrogrit® is 5’0″
Maximum length on all others is 6’0″
Concealed integral anchors standard
LADDER RUNG
Type 950 - Alumogrit ONLY - 2″ x 18″ ONLY
FOR STEEL PAN
Type 101SP - Nose 3/8″.
Chief use: as nosings on steel-pan concrete-filled stairs.
Type 102 - Nose 1/2″ x 3/8″.
Chief use: as nosings on steel-pan stairs. Can also be used structurally with bent-plate risers.
Type 103 - Nose 3/4″ x 3/4″.
Chief use: as structural treads with bent-plate risers or as nosings full width of stair.
MISCELLANEOUS USES
Type 100 - Square edges.
Chief uses: floor plates, trench covers, stair landing platforms, expansion joint covers.
Type 110 - Rounded edges.
Chief uses: Expansion joint covers, platforms around machinery, deck treads.
Type 120 - One edge rounded.
Chief uses: nosings on steel grating treads and for special conditions, usually superimposed.
Sweetsstakes