Series 248 EverThane - Aliphatic Moisture Cured Urethane

Generic Type

Aliphatic Moisture Cured Urethane

Common Usage

Extremely hard, chemical-resistant urethane floor coating with superb wear characteristics. Excellent resistance to abrasion, wet conditions, corrosive fumes and chemical contact. Excellent gloss and color retention. Low odor characteristic allows for use near occupied space.

Series 66, 66HS, 161, 161HS, 210, 237, 238, 256, 280, 281, 284, 285, 287
Note: Applying Series 248 to one of the listed primers or intermediate coats does not require sanding if the maximum recoat window for the primer or intermediate coat has not been exceeded. However, when applying Series 248 over smooth, slick, glossy surfaces it is good practice to uniformly degloss the surface by power sanding with 100 grit sandpaper, a 60 mesh sanding screen or a coarse stripping pad to eliminate surface tension and any potential for possible contamination in the surface that may lead to fisheyes and/or poor adhesion. Sanding is not required when topcoating textured coatings (i.e. aggregate or colored quartz broadcast to refusal) with Series 248 if the maximum recoat window for the primer or intermediate coat has not been exceeded. Note: When applying Series 248 over a broadcast or mortar system, a 100% solids epoxy grout coat or Series 256 is required.

Semi-gloss. Note: The gloss level can be reduced by adding two Part C filler components to each kit.

92 ± 2.0% (clear mixed) †

Unthinned: 0.68 lbs/gallon (82 grams/litre) †

1,476 mil sq ft/gal (36.2 m²/L at 25 microns). See APPLICATION for coverage rates. †

Temperature - Min. Recoat ‡ - To Service - Chemical Resistance

75°F (24°C) - 12 hours - 24 hours - 7 days

‡ When recoating, the surface must be thoroughly scarified using 60 grit sandpaper.
Curing time varies with surface temperature, air movement, humidity and film thickness.

Concrete: Series 66, 66HS, 161, 161HS, 201, 205, 237, 238, 256, 280, 281, 287. Note: Series 248 can be applied directly to concrete if a single coat urethane sealer is desired.

2.0 to 3.0 mils (50 to 75 microns) per coat. Note: Number of coats will vary depending on color, substrate (surface) and other variables. Contact your Tnemec representative.

Three: Part A, Part B (clear) and Part C (powder)

See More

See Less