Wall Panels - Flush
Flush panels are designed for wall, fascia and soffit applications where a flush or flat appearance is desired. A rounded interlock leg and concealed fastening system improves the flush appearance while providing additional strength. Panels are factory-formed to length to minimize field cutting. Maximum panel length is 25’ and minimum panel length is 4’.
Flush panels are available in on-center dimensions designed to complement Petersen’s roofing panel product line. Flush panels are available in Flush and Reveal joint configurations.
The Flush and Reveal panels are available with optional stiffening beads. Stiffening beads are recommended for longer panel lengths. One or two beads are available.
Flush panels shall be installed over a solid substrate with appropriate ice and water shield, or in limited applications over framing sections. When used in a windscreen application, panels must be fastened (stitched) through side joints. Consult a local architect/engineer for requirements of local codes and conditions.
Petersen’s Flush panels are formed on precision roll-forming equipment that includes levelers. Leveling removes typical metal conditions including coil set, crowning and edge wave. Leveling is available at no extra charge.
All flashing and trim shall be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032 - .063 gauge as specified) or PAC-CLAD steel (24 gauge or 22 gauge as specified). A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl masking is recommended on all fabrication applications where extra handling is expected.
- 43 stocked colors (24 gauge steel)
- 16 stocked colors (22 gauge steel)
- 36 stocked colors (.032 aluminum)
- 22 stocked colors (.040 aluminum)
- Galvalume Plus available
- Leveled for flatness
- Available with up to two stiffener beads
- Rounded interlock leg provides improved flush fit
- 30-year non-prorated finish warranty
- Panel lengths from 4' to 25’