Foster™ -Foster® 10-42 Pumpable Cold Sealer

DOWNLOADS

FOSTER PUMPABLE COLD SEALER FOSTER Pumpable Cold Sealer is a non-skinning, high solids, non-setting, seam and joint sealant for metal air ducts. It remains soft and flexible preventing damage to the seal due to thermal cycling through a wide range of temperatures. It has good pumpability, yet quickl


Category: air duct sealants | construction sealants | duct sealants...

MasterFormat: Joint Protection | Joint Sealants | HVAC Air Distribution...


Related Products

Overview


Foster® 10-42 Pumpable Cold Sealer



FOSTER PUMPABLE COLD SEALER

FOSTER Pumpable Cold Sealer is a non-skinning, high solids, non-setting, seam and joint sealant for metal air ducts. It remains soft and flexible preventing damage to the seal due to thermal cycling through a wide range of temperatures. It has good pumpability, yet quickly achieves excellent blow out resistance. It is designed for use with sheet metal fabrication machines that form locking joints.

Pumpable Cold Sealer has excellent adhesion to a wide variety of non-porous surfaces. It provides an air tight, long lasting seal for metal-to-metal joints and seams. Mechanical fasteners of the type and number normally used for duct assemblies are required to provide rigidity to the duct system.

Pumpable Cold Sealer's fiber free and grit free formulation will not clog pumps, hoses, or nozzles.

Pumpable Cold Sealer contains no asbestos, lead, mercury, or mercury compounds.

Pumpable Cold Sealer meets requirements for LEED IEQ 4.1 Low-Emitting Materials, Adhesives and Sealants. VOC: 173 g/l, less water and exempt solvents.

LIMITATIONS
Store and apply between 40°F (4°C) and 100°F (38°C).

Allow 48 hours before pressure testing. Not suggested for exposed (surface) application.




COLOR:
Cream/Tan

APPLICATION CONSISTENCY:
Power extrusion

AVERAGE WEIGHT/U.S. GALLON (ASTM D 1475):
11.1 lbs. (1.33 kg/Liter)

AVERAGE NON-VOLATILE (ASTM D 1644):
88% by weight

COVERAGE RANGE:
1,500 linear ft./gallon, 1/8" round bead. (121 m/l, 3.2 mm bead)

DRYING TIME:
Set to Touch: 24 hours @ 77°F. (25°C.) Essentially non-drying

SERVICE TEMPERATURE LIMIT:
-50°F. to 200°F. (-46°C to 93°C.)

WET FLAMMABILITY (ASTM D 2378):
Flash Point 115°F. (46°C)

COMBUSTIBILITY (DRY) (FSTM 44):
Combustible. Flame spread and fuel contribution negligible when used in a 1/8 in. (3.2mm) round bead.

SURFACE BURNING CHARACTERISTICS (ASTM E 84):
Flame Spread: 0
Smoke Developed: 0 Tested as applied in two 1/8 " beads spaced 8 in. on center.
Applied to 1/4 inch (6.4 mm) inorganic reinforced cement board. The flame spread may vary at different product thicknesses and/or when applied over other surfaces.


TM TradeMark of H.B. Fuller Construction Products Inc.

Visit us on the web at www.fosterproducts.com


See More


Sweetsstakes