Terrazzo Model 100 Receptors
Furnish and install Model 100 terrazzo receptor as manufactured by Florestone Products Company. Shoulder will be not less than 2½" inside. Flange, cast integral, will be galvanized-bonderized steel and extend not less than one inch (1") above shoulder on four sides for installation. Drain body will be brass, cast integral, and will provide for a non-caulked connection not less than one inch deep to a two inch pipe. Receptor will be manufactured of tan and white marble chips cast in white Portland cement to produce a compressive strength of not less than 3,000 PSI, seven days after casting. Terrazzo surface will be ground, polished, and the entire unit sealed to resist stains and moisture after any air holes and/or pits are grouted. Receptor will be reinforced with 16 gauge wire. Removable type stainless steel strainer plate will be supplied.
Offset drain. (Drawings required)
Dimensions may vary ± ¼ inch. Please check unit before installation.
Place receptor on a minimum ¼" bed of mortaror plaster for warranty compliance.
Note: Terrazzo is not designed to be used with anything that is over 130 degrees Fahrenheit.
Center drain terrazzo shower receptor with 1¼" flanges on all four sides.