Berridge Metal Roof and Wall Panels -Curved or Tapered Tee-Panel Standing Seam System

DOWNLOADS

The Berridge Curved Tee-Panel is an ideal roofing choice for concave, convex or compound curved corners and domed roof construction with solid sheathing.


Category: conical roofing | integral standing seam roofing | metal roofing...

MasterFormat: Roofing and Siding Panels | Roof Panels | Metal Roof Panels...



Berridge Metal Roof and Wall Panels
2610 Harry Wurzbach
San Antonio, TX 78209
Tel: (800) 669-0009
Fax: (210) 650-0379

info@berridge.com

https://www.berridge.com/

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Curved or Tapered Tee-Panel Standing Seam System

The Berridge Curved Tee-Panel is an ideal roofing choice for concave, convex or compound curved corners and domed roof construction with solid sheathing. This panel can be curved or tapered on site, allowing for versatility with the added benefit of the exclusive vinyl weatherseal that is a part of the snap-on seam.

Materials
24 Gauge Steel
Limited Availability: 22 Gauge Steel, 0.032 Aluminum

Specifications
Uses: Roof, Fascia*
Coverage: 12 3/4"
Finishes: Smooth
Fasteners: Concealed
Applications: Solid sheathing
Seam: 1" snap-on with extruded vinyl weatherseal

Installation
For Roofing applications only
Tee-Panels and snap-on seams can be curved in continuous length panels on site using the Berridge SS-14 Roll Former
Convex at a minimum of 4’
Concave at a minimum of 6’
Straight or curved Tee-Panels can be formed on site with the Berridge SL-14 Roll Former
Compound Curved Tee-Panels are formed on site with the Berridge SL-1 Roll Former. The SL-1 does not curve panels. Panels must be hand curved over solid decking
Snap-on seams are curved using the SS-14 Roll Former or the SC (Seam Curver) Roll Former
Extra snap-on seam caps are factory formed to a maximum of 40’
Use Seam Sleeve for splicing Tee-Panel snap-on seams
Entire roof area shall be covered with Berridge approved underlayment
Use 1” Folding Tee-Clip typically at 24” O.C. with Tee-Panel
Use 1” Stainless Folding Tee-Clip typically at 12” O.C. with Aluminum panels

Note: * Fascia can not be curved or tapered


See More


Specifications

Sweetsstakes