Berridge Metal Roof and Wall Panels -Batten Seam Panel

DOWNLOADS

The Berridge Batten Seam Panel system is a two-part system utilizing the Deep Vee Panel and square snap-on battens for bold panel lines. This system may be installed over open framing or solid sheathing and uses concealed fasteners to create its smooth, wide seam appearance.


Category: acrylic coated metal roofing | batten seam roofing | box batten seam roofing...

MasterFormat: Roofing and Siding Panels | Roof Panels | Metal Roof Panels...



Berridge Metal Roof and Wall Panels
2610 Harry Wurzbach
San Antonio, TX 78209
Tel: (800) 669-0009
Fax: (210) 650-0379

info@berridge.com

https://www.berridge.com/

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Batten Seam Panel

The Berridge Batten Seam Panel system is a two-part system utilizing the Deep Vee Panel and square snap-on battens for bold panel lines. This system may be installed over open framing or solid sheathing and uses concealed fasteners to create its smooth, wide seam appearance.

Materials
24 Gauge Steel

Specifications
Uses: Roof, Fascia
Coverage: 16"
Finishes: Smooth
Fasteners: Concealed
Applications: Open framing, solid sheathing
Seam: 2" wide and 1 3/4" high snap-on batten cap

Installation
Deep-Vee Panel, snap-on batten cap, and the batten seam inner rib** are available from the factory in continuous lengths to a maximum of 40’
May be site formed in continuous lengths with the Berridge BP-21 Roll Former
Use Batten Clip typically at 20” O.C. along each panel rib
Estimate 50 clips/sq with 1 fastener/clip
Use Batten End Cap as mechanical closure at bottom of panel runs
Use Zee-Flashing as mechanical weather closure at ridges, hips, etc. Field cut to fit between panel legs
Use Standard Channel at end walls and flashed area*
Use Special Channel at gable ends and area where color will show on all sides*
Use Snap-On Batten Cap continuously at panel side joints. Estimate 75 LF/SQ. See typical details for splice and eave turn-downs
Use Batten Seam Inner Rib** with Inner Rib Expansion Clip to allow for thermal movement of panels over 30’ long

* Trim Drawing with dimensions and finish side required for all Berridge manufactured trim pieces

** Batten Seam Inner Rib required for UL 90 certification


See More


Specifications

Sweetsstakes