Hohmann & Barnard, Inc.
30 Rasons Court
P.O. Box 5270
Hauppauge, NY 11788-0270
Telephone: (516) 234-0600
FAX: (516) 234-0683
Website: http://www.h-b.com/

Joint reinforcement for single wythe walls shall be Lox All^® Ladder Mesh, as manufactured by HOHMANN & BARNARD, INC., Hauppauge, NY, or approved equal. Reinforcement shall be fabricated from cold-drawn steel wire conforming to ASTM A82, with smooth (state dia.) cross rods butt welded not more than 16" o.c. to deformed (state dia.) side rods. Finish shall conform to (state spec.). Factory prefabricated Corners and Tees shall be used at all corners and intersecting walls and shall be of the same gauge, finish and design as the continuous joint reinforcement.

* This specification can be modified for composite or cavity walls with the inclusion of any of the HOHMANN & BARNARD Lox All^® products on this screen.

• Packed 500 ft. per bundle (50 pcs. – 10 ft. long).
• Tri-Mesh, Twin Mesh and Box-Mesh packed 250 ft. per bundle (25 pcs. – 10 ft. long).
• Corners and Tees packed 25 pcs. per bundle.

H & B recommends Type 304 or Type 316 Stainless Steel for maximum protection against corrosion.

Lox All^® Ladder-Box-Mesh

Box-Mesh is a prefabricated anchoring and reinforcing assembly with 4 in. wide boxes welded 16 in. o.c.

• #250 is a single-unit veneer system.
• #255 adds cavity drip to #250.
• #260 offers vertical adjustability. Boxes extend only into collar joint and accept a standard rectangular pintle to anchor exterior wythe.
• #265 is similar to #260 but has a restraint bar welded to each box as shown. For cavity or insulated walls, this prevents in and out movement of the rectangular pintle.