RJ-711 Adjustable Veneer Anchor

Plate is available in either 14 ga. or 12 ga.; wire is 3/16" diameter. Available in mill galvanized, hot dipped and stainless steel. Hook lengths are 3-1/4", 4-1/4" and 5-1/4". Hook adjustments are a maximum of 1-1/4" up or down. Also available for insulated walls.

In RJ-711 chart, a tension/pull out load was applied to samples using a loading fixture positioned in a calibrated testing machine. A proof load of 100 lbs was applied and held for 30 seconds. A deflection reading in inches was taken prior to continuing the test to failure.

HCL-711 Anchor

An adapation of the popular RJ-711, HCL-711 has two new pointed prongs which pierce wallboard and abut to backup (steel stud). 14-gauge prongs allow little or no compressible movement where wallboard may deteriorate.

Useful in high wind environments and seismic areas III and higher where wall board is installed between steel stud and insulation. Prong design extends through 5/8" wallboard; plate extensions accommodate up to 2" insulation. Anchor plates and ties are hot dipped galvanized or stainless steel to meet ACI 530 code requirements for masonry structures. Screws (top and bottom) recommended when attaching anchor plate to stud to add strength and stability to system. Packaged 250 pcs/box. HCL anchor plates (14g) and 3/16" adjustable double hooks available in hot dipped galvanized and stainless steel.

WIRE-BOND®

Corporate Office
400 Roundtree Rd
P.O. Box 240988
Charlotte, NC 28224
Tel: (704) 525-5554
Toll-Free: (800) 849-MRCA (6722)
Fax: (704) 525-3761
Web site: http://www.wirebond.com

Memphis Plant
2365 Harbor Ave.
Memphis, TN 38113
Tel: (901) 775-9444
Toll-Free: (800) 441-8359
Fax: (901) 775-9449

04082/MAS
BuyLine 0452