SHOP FLOOR FIREHOUSE EPOXY FLOORING

DESCRIPTION

SHOP FLOOR FIREHOUSE EPOXY FLOORING is a combination of "colored" Dur-A-Glaze-Shop Floor, a 100% solid's epoxy formulation, and Ottawa Flintshot, a natural quartz sand. The epoxy and the quartz aggregate are fused together during application into a monolithic surface that is extremely durable. The surface texture can be standard non-skid, orange peel or smooth finish. It can be applied on most any type of sound substrate including concrete, quarry tile, brick pavers, steel decks, plywood floors, etc. Dur-A-Flex's exclusive, clear, two-component epoxy, DUR-A-GLAZE, is the secret for the success of this flooring system. SHOP FLOOR FIREHOUSE EPOXY FLOORING is similar in application technique, durability and chemical resistance as the time tested Dur-A-Quartz "BM" Epoxy Flooring. It is not quite as decorative but it is more economical because it utilizes less expensive, locally available Ottawa Flintshot quartz sand instead of the more decorative Q28 Colored Quartz. Outstanding features are:

– Excellent Clarity
– Rapid Hardening
– Good UV Resistance
– No Odor
– USDA Approved
– Superior Adhesion
– Desirable Viscosity
– Superior Chemical Resistance
– Cures Blush-Free (no exudation)
– Applies Without Cratering
– Easy to Use 2:1 Mix Ratio
– Applies Bubble-Free
– Low Irritation Potential
– Competitively Priced

TYPICAL USES
SHOP FLOOR FIREHOUSE EPOXY FLOORING is specifically designed for use in apparatus bays, municipal vehicle maintenance areas, emergency service vehicle areas, bus maintenance and wash areas. It is ideally suited for heavy duty vehicular traffic in areas requiring durability, easy maintenance, a high degree of cleanability, and high acid and chemical resistance. SHOP FLOOR FIREHOUSE EPOXY FLOORING will protect a new concrete floor from industrial abuse and harsh chemical spillage, and it will restore deteriorated concrete into a better than new condition.

BENEFITS
– Low initial installation cost.
– Very neat, uniform surface appearance. No trowel marks.
– Lowers maintenance costs. Very easy to keep clean.
– Nearly indestructible. Most durable of all epoxy flooring materials.
– Installs and cures rapidly, short "downtime" period.
– Easy to keep sanitary due to its stain resistant, non-porous, seamfree surface, with integral cove base if specified.

COLORS
Common colors are Tile Red and Slate Gray. However, any standard DUR-A-GARD color is available.
(See color chart in "Dur-A-Gard Floor & Wall Epoxy" Snapshot.)

LIMITATIONS
Substrate and ambient temperature must be higher than 50°F during installation and curing period. NOTE: "Cold Cure" version will cure at lower temperatures but some discoloration may occur.

SURFACE PREPARATION – Surface must be dry and perfectly clean, free of all oil, grease, detergent film, sealers and/or curing compounds in accordance with Dur-A-Flex, Inc., document entitled "Preparation Guidelines" in "Preparation/Application Details" Showcase.

PHYSICAL PROPERTIES
(See table on this screen.)

Before using any Dur-A-Flex, Inc. product, be sure the Material Safety Data Sheet is read and understood.

Dur-A-Flex, Inc.
95 Goodwin St.
East Hartford, CT 06108
Phone: 860 528-9838
Toll Free: 800 253-3539
Fax: 860 528-2802
Email: info@dur-a-flex.com
Website: www.dur-a-flex.com