This is the installer's choice for a wet seal ACM system. A rout and return system that utilizes the same extrusion on all sides of the panel, NWX4 is a "non-progressive" system that allows varying project conditions to dictate starting and stopping points with no adverse affect on schedule or quality.
A specially designed attachment extrusion eliminates the need for horizontal subgirts, and has a built in spacer that maintains accurate panel joint width during installation then breaks away under the force of thermal movement.
NWX4 works great for wall cladding, soffit cladding, canopies, vestibules, beam cladding and any application where termination points and complex panel shapes and details cause problems for other systems.
- Wet Seal System
- Non-Progressive System
- Continuous aluminum extrusion system eliminates need for horizontal sub-framing
- Break away joint spacer
- Works with 4mm or 6mm ACM
- Wall Cladding
- Soffit Cladding
- Fascias
- Screen Walls
- Beam Cladding
- Canopies
- Vestibules
- High Performance Paint
- Anodized
- Brushed Aluminum
- Zinc
- Stainless Steel
- Copper
- 4mm Aluminum Composite Material
- 6mm Aluminum Composite Material
- System Depth = 1 1/2”
- Panel Joint Width = 1/2”
- Maximum Panel Height = 60”
- Minimum Panel Height = 8”
- Maximum Panel Length = 238”
- Minimum Panel Length = 12”
Armetco Systems, Inc.
Armetco Drive
Justin, TX 76247
Tel: (800) 647-3778
Fax: (940) 648-2866
Web site: info@armetco.com
E-mail: http://www.armetco.com
|