Rangine Corporation/Rakks 330 Reservoir Street Needham, MA 02494 Toll-Free: (800) 826-6006 Fax: (781) 455-8702 E-mail: sales@rakks.com Web site: http://www.rakks.com 
Rakks Counter Support Brackets provide a practical low cost and easy to install alternative to full-height laminated panel supports. They support counters up to 30" deep while providing open space under the entire length– improving both handicap accessibility and ergonomics. Counter Brackets are available in either surface or flush-mounted configurations. Rakks Sill Supports provide low-profile support or bracing for shelves or sills.
EH-1212 Used to support counters up to 18" deep or incorporated into casework to provide structural bracing. Brackets can be easily cut down in the field to accommodate shorter counters. EH-1818 For counter up to 25" deep, brackets should be screwed into blocking or studs at a maximum spacing of 48 inches. 2" wide mounting surface provides extra support where counter sections join. EH-1824 Used to support up to 30" deep counters. These lightweight and easy-to-ship brackets are manufactured from 2" x 3" “T” to provide maximum stiffness. When the 24" leg is against the wall, this bracket can also be used to support 24" deep counters. FLUSH MOUNT Used in applications requiring a nearly invisible support, any EH bracket can be ordered in the flush mount configuration. Flush mount brackets use a 2" x 2" x 1/4" L-shaped vertical leg that is screwed to the side of the stud. After installation of the bracket, drywall is mounted to the studs, hiding the vertical support leg. BENCH MOUNT Used for benches incorporating 5" wooden planking. The supporting arm is pre-drilled with 12 holes to provide secure installation. Wall-mounted design keeps floor unobstructed and easy to clean. Manufactured from 2" x 3" “T” to provide maximum stiffness. SILL SUPPORT Manufactured from structural aluminum angle, these brackets can be used anywhere low profile support or bracing is required. additional information available at rakks.com |