Roof Hatch/Skylight Systems:

Finally - A Fall Prevention System that protects your investment while Complying with OSHA regulations!

SR2K is THE ONLY non-penetrating system on the market today that fully complies with OSHA regulations unlike other available systems.
(Certified test results to document the compliance are available upon request).

A setup using a chain DOES NOT meet (Standards - 29 CFR ) 1910.23 (a)(2)
The chain does not provide a mid-rail as required.
Visit http://www.osha.gov/pls/oshaweb/
owadisp.show_document?p_table=INTERPRETATIONS&p_id=18995
to see the most recent OSHA interpretation.

1910.23(a)(3)(i)
Hinged floor opening cover of standard strength and construction equipped with standard railings or permanently attached thereto so as to leave only one exposed side. When the opening is not in use, the cover shall be closed or the exposed side shall be guarded at both top and intermediate positions by removable standard railings.

Do Not Void Your Warranty!

• Stop Drilling into Roof Decks.
• Stop Drilling into Roof Hatch and Skylight Curbs.
• Stop Drilling into Floors.
• Stop Drilling - Period!

Features:

• Non-Penetrating.
• Independently tested and shown to meet and exceed OSHA Fall Protection Regulations for Guardrails.
• Sets up in minutes.
• The engineered bases enables the system to be set up in numerous configurations (L-Shapes, Straight Runs, Etc.).
• Easily dismantled for roof deck repair.
• The gate can be opened by the latch pole or by one of the latches.
• 1-5/8" diameter rails have a quality Powder Coat finish.
• Use as roof hatch, skylight, fire vent and floor door protection.

In most situations, OSHA (Std. 29 CFR 1910.23) requires guardrail protection on the exposed sides of openings in roofs and floors.

BlueWater Mfg. has modified our SafetyRail 2000 guardrail system to meet those safety concerns. Our Roof Hatch/Skylight Systems exceeds OSHA Std. 29 CFR 1910.23 and 1910.27. It is the only product available in the market with a gate assembly that meets the same OSHA regulations and requires no drilling into any surface for installation. The Roof Hatch/Skylight Systems set up in minutes and are easily dismantled for roof repair. Sized gates enable the Roof Hatch System to be located within 6 inches of the open roof hatch.

We can configure or custom manufacture to any size hatch that is not listed above. Please contact us for more information.

The Grab Bar allows for easy egress and ingress of roof hatches and floor hatches. Install the Grab Bars as an option to the Fall Protection Hatch Kits and make it easier and safer for workers. The Grab Bar mounts to an open receiver on the SafetyRail 2000 base. Adjust the width of the bars to the width of the ladder inside the hatch or a little wider. Lock the Grab Bars into place with the securing pin and tighten the friction collar and your done. The Mount Pad is adjustable and enables the bars to be used when curbs are place in front of the hatch or on uneven surfaces. Note: Roof Hatch Kits will need longer side rails when using the Grab Bar. Contact the factory to size the Hatch Kit. Part # 500296 (2ea required per hatch)