TruClimate 100 - Water-to-Water Heat Pump

Up To 17.4 EER

Up To 5.1 COP

Features compact cabinet designs and Aurora Standard controls.

Impressive Efficiency in a Compact Cabinet

The TruClimate 100 is a premium efficiency reversible scroll chiller housed in a compact cabinet for easy installation. It fits through typical doorways and features external fork truck lifting points for simple retrofits.

Advanced Controls

The HydroLink Aurora controls platform provides numerous factory-installed options for better service, diagnostic, and monitoring ability. New features include refrigerant, energy, and performance monitoring through the HMI or through DDC protocols. Available on units 8 tons and above, products 6 tons are available with the Aurora Base Controls.

Building Electrification Instead of Fossil Fuels

The TruClimate 100 water-to-water heat pump chillers don’t rely on natural gas, which helps the building owner reduce fossil fuel consumption and their carbon footprint impact on the environment. The heat wasted through a cooling tower or ground loop is recovered and used for hot water pre-heat.

* Data based on an average commercial building in CBECS from the U.S. Energy Information Administration. Actual energy savings may vary.

Domestic Hot Water

Our storage tanks are UL Certified for electric water heaters, and water storage comes with factory-installed temperature/pressure relief valves. The tanks are glass-lined with primary and secondary aluminum anode rods which provide maximum protection against corrosion. The brass tamper-resistant drain valve provides durability and longer life than plastic valves. Available on 10-30 ton units.

Serviceability Benefits

Our control panel was designed with the technician in mind to provide convenient, straightforward wiring with plenty of working space. The panel is split into left and right sides with access to both for ease of service.

Set Point Control

Factory-installed leaving/entering water temperature sensors or a remote temperature sensor option is available to assist in set point control. Available on units 8 tons and above.

High Efficiencies Through Dedicated Heat Recovery

By utilizing a pre-heat strategy for hot water, the TruClimate 100 can reduce the load on the cooling tower, minimize energy consumption, save money and address the energy side with pre-heat.

Quality Components for Efficient Operation

Oversized true brazed plate heat exchangers offer high efficiency with industry-low waterside pressure drop, while dual scroll compressor technology provides consistent reliability and efficiency.

Other Key Features

Factory-Installed Options

A factory-installed pressure/temperature port is externally accessible for improved serviceability, while factory-installed high accuracy sensors measure system pressures and temperatures. Factory mounted, internally wired, non-fused disconnect is also available.

Noise-Dampening Features

The compressor suction/discharge tubes come with a braided stainless steel vibration absorber to dampen compressor vibration on system piping resulting in quiet operation.

Phase Guard Monitor

Provides phase reversal, phase imbalance, and loss of phase protection.

Brazed Plate Heat Exchanger

Large oversized stainless steel interlaced copper-brazed plate water-to-refrigerant heat exchangers provide unparalleled efficiency.

Separate Refrigerant Circuits

Refrigerant circuits for heating and cooling are separate with a standard water supply to provide the best part-load efficiency compared to using two single circuit heat exchangers.

See More

See Less