Petersen Aluminum Corporation - Redi-Roof Batten Panel

Redi-Roof Batten Panel


Category: copper roof panels | copper roofing | copper roofing paenls

MasterFormat: Metal Roof Panels | Flashing and Sheet Metal | Standing Seam Sheet Metal Roofing...



Petersen Aluminum Corporation
1005 Tonne Road
Elk Grove Village, IL 60007
Tel: (800) 722-2523
Fax: (800) 722-7150

info@pac-clad.com

https://www.pac-clad.com

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Redi-Roof Batten Panel

Redi-Roof may be specified in either a batten or standing-seam profile and is intended for application over a solid substrate with a minimum 3:12 roof pitch. Typical underlayments include plywood, nailboard insulation or equal. Panels are factory roll-formed in continuous lengths. Maximum panel length is 45’ and minimum panel length is 4’.


Redi-Roof panels feature an offset profile which adds strength and allows room for a hex head fastener. The clip, with its button-punched design, ensures an extra-snug fit. The one-piece design allows for ease of installation.

Trim

Redi-Roof may be specified in either a batten or standing-seam profile and is intended for application over a solid substrate with a minimum 3:12 roof pitch. Typical underlayments include plywood, nailboard insulation or equal. Panels are factory roll-formed in continuous lengths. Maximum panel length is 45’ and minimum panel length is 4’.


Redi-Roof panels feature an offset profile which adds strength and allows room for a hex head fastener. The clip, with its button-punched design, ensures an extra-snug fit. The one-piece design allows for ease of installation.

Installation

Redi-Roof panels shall be installed over solid decking with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen Aluminum nonpenetrating clips, fastening on 18” centers (max.). Minimum slope at 3:12 pitch. Redi-Roof batten panels cannot be lapped in the field. Consult a local architect/engineer for requirements of local codes and conditions.

Materials:
  • 38 stocked colors (24 ga. steel)
  • 15 stocked colors (22 ga. steel)
  • 36 stocked colors (.032 aluminum)
  • 16 oz. cold rolled copper

  • See More

    Features
    • Available with offsets

    • Factory eave notching available

    • Herr-Voss corrective leveled

    • Labor-saving one-piece design

    • Stiffener beads available

    • 30-year non-prorated finish warranty

    • Panel lengths up to 45’


    Sweets app for Revit – Learn More