Petersen Aluminum Corporation - High Snap-On Standing Seam Panel

High Snap-On Standing Seam Panel


MasterFormat: Metal Roof Panels | Flashing and Sheet Metal | Standing Seam Sheet Metal Roofing...



Petersen Aluminum Corporation
1005 Tonne Road
Elk Grove Village, IL 60007
Tel: (800) 722-2523
Fax: (800) 722-7150

info@pac-clad.com

https://www.pac-clad.com

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


High Snap-On Standing Seam Panel

Snap-On panels are ideal for use in roofing, mansard and fascia applications. Snap-On panels are designed to be installed over a waterproofed solid substrate and a minimum 3:12 roof pitch. Snap-On panels are factory roll-formed in continuous lengths. Maximum panel length is 45’ and minimum panel length is 4’.


These panels are ideal for specification on applications where roof transitions are required. The simplicity of the pan design combined with corrective leveling provides superior flatness and allows for greater workability on site.

Trim

All flashing and trim shall be fabricated by manufacturer or qualified fabricator. Flashing shall be PAC-CLAD aluminum (.032 – .063 gauge as specified) or PAC-CLAD steel (24 gauge or 22 gauge as specified). A 30-year non-prorated finish warranty can be supplied covering finish performance. Vinyl masking is recommended on all fabrication applications where extra handling is expected. NOTE: The strippable film must be removed immediately after installation.

Installation

Snap-On panels shall be installed over solid decking (5/8” plywood, nailboard insulation or equal) with an underlayment of 30# (min.) roofing felt applied horizontally from eave to ridge. Panels shall be fastened using Petersen Aluminum nonpenetrating clips, fastening on 18” centers (max.). Minimum slope at 3:12 pitch. Consult a local architect or engineer for requirements of local codes and conditions.

Curved Panels

The 1” high Snap-On standing seam panel can be curved to a concave or convex radius, with a minimum radius of 9’. This panel is ideal for barrel vaults and entrance ways. Curved panels must be installed over a waterproofed solid substrate.

Materials:
  • 38 stocked metal colors (24 gauge steel)
  • 36 stocked metal colors (.032 aluminum)
  • Galvalume Plus available

  • See More

    Features
    • Ideal for transition roofs

    • Herr-Voss corrective leveled

    • Stiffener beads available

    • 30-year non-prorated finish warranty

    • Panel lengths up to 45’


    Sweets app for Revit – Learn More