Childers™ - CHIL-BRATE™CP-25 Weather Barrier Coating

DOWNLOADS

CHIL-BRATE CP-25 is a water based fire retardant fibrated asphalt emulsion weather barrier coating for use over insulations on above ground installations operating at moderate to high temperature service.


Category: fire retardant paints | fire-resistant coatings | fire-retardant coatings...

MasterFormat: Thermal Protection | Painting and Coating | High-Performance Coatings...


Related Products

Overview


CHIL-BRATE™CP-25 Weather Barrier Coating

WATER BASED FIBRATED ASPHALT EMULSION WEATHER BARRIER INSULATION COATING

CHIL-BRATE CP-25 is a water based fire retardant fibrated asphalt emulsion weather barrier coating for use over insulations on above ground installations operating at moderate to high temperature service. Since it is a “breathing” coating, vapors under pressure will pass through it. When dry, the film is tough and durable. It provides protection against atmospheric corrosives, chemical liquids, and fumes.

USES

CHIL-BRATE CP-25 weather barrier coating is primarily designed to protect insulation on equipment and structures in high temperature service, although it also provides protection against corrosion when applied directly over steel and concrete. Typical insulations protected with CHIL-BRATE weather barrier coating include calcium silicate, mineral and glass fibers, polyurethane, and glass foams. It is not recommended in ponded water areas or over polystyrene foam insulation.

APPLICATION

All surfaces must be clean and dry. DO NOT THIN. CHIL-BRATE CP-25 is designed to be applied by trowel. A two-coat application of equal thickness is recommended, with a glass fiber membrane (Chil-Glas® #5 or #10 glass cloth) embedded into the tack coat. Chicken wire should not be used. Total coverage shall be 15 gallons per 100 sq. ft. (6.1 liters/sq.m), 0.12” (3 mm) dry film thickness. Foot or mechanical traffic is NOT recommended for roof or tank top applications where high ambient temperatures may soften the mastic film. Not recommended for indoor use. This product cannot be successfully applied by brush or spray. Outdoor horizontal surfaces must always drain completely. A pitch of at least ½” per foot (4 cm/m) is required

ADVANTAGES
  • Water based for personal and environmental safety.
  • Highly resistant to acids, alkalis and salts .
  • Meets requirements for LEED IEQ 4.2 Low-Emitting Materials, Paints and Coatings. VOC: 0 g/l, less water and exempt solvents.
COLORS

Black

WET WEIGHT

8.7 lbs./U.S. Gallons
(1.04 kg/liter)

AVERAGE NON-VOLATILE

50% by volume
52% by weight

SERVICE TEMPERATURE RANGE

(Temperature to which dry film is subjected.)
- 20ºF to 200ºF
- 29ºC to 93ºF

APPLICATION STORAGE TEMPERATURE RANGE

( Temperature of product when applied)
PROTECT FROM FREEZING
40ºF to 100ºF
4ºC to 38ºC

DRYING TIME

(Drying time will vary depending upon film thickness, temperature, and humidity.)
24-48 hours

COVERAGE

15 gallons per 100 sq. ft. (6.1liters/sq.m)
Varies with substrate and membrane.

CLEAN-UP

Clean water, followed by mineral spirits.

CP-25 contains no asbestos, lead, mercury, or mercury compounds.


See More


Sweets app for Revit – Learn More