ADHESIVES AND CAULK
No. 400, 560, 775, 110

R.C. Musson Rubber Co.
1320 E. Archwood Ave.
P.O. Box 7038
Akron, OH 44306
Tel: (330) 773-7651
(800) 321-2381
Fax: (330) 773-3254

No. 400 NEOPRENE CONTACT ADHESIVE

Product Description

For bonding all Disc-O-Treds, Rubber Stair Treads or Koroseal Vinyl Stair Treads to concrete, pan-filled, wood, metal, marble and terrazzo steps. A rapid drying, long range contact cement; especially formulated for Musson stair coverings. Brush on application; use on back of treads and back of nosing. Contains solvents, extremely flammable. 1 gallon covers 150 sq. ft.; brush on back of tread and on step; installs 75 sq. ft. of material. Ready to use in 1 qt., 1 gal., and 5 gal. containers.

No. 560 RUBBER FLOORING ADHESIVE
Environmentally friendly

Product Description

For installing Rubber Floor Tiles or Rolls over suitable on-grade dry concrete floors, suspended concrete floors, or suspended wood floors. May also be used with sanded back molded rubber Stair Treads; use on back of treads and back of nosing. Not recommended where excessive moisture exists. Non-carcinogenic; non-toxic. See label for complete instructions. Latex adhesive is safe for the environment and freeze thaw stable. Ready to trowel in 1 gallon or 4 gallon pails. Covers 150 sq. ft. per gallon.

No. 775 EPOXY ADHESIVE
Environmentally friendly

Product Description

The only recommended adhesive for use with Disc-O-Tile is Epoxy Adhesive. May be used with other Rubber Stair Treads, Tile and Flooring or Koroseal Vinyl Treads, use on back of treads and back of nosing. Because of flame spread properties other adhesives will not properly bond Disc-O-Tile to the floor. (Epoxy Adhesive gives the strongest bond for all stair treads – but – until the "setting" of adhesive begins, there is no "grab or hold." Use extreme care to assure that tread does not move forward leaving an air gap under the nose.) A two-part solvent free epoxy adhesive; contains 1 can Part A and 1 can Part B and a stirring paddle. Both Part A and Part B are in 1 gallon cans so one part can be poured into the other to produce 1 gallon of adhesive. Covers approximately 150 sq. ft. per unit.

No. 110 EPOXY STAIR NOSE CAULK
Environmentally friendly

Product Description

Epoxy Stair Nose Caulk is recommended for all Stair Tread installations; Nose Caulk is necessary when installing Adjusta-Nose Treads or when the step nosing is broken, worn or rounded. This two-part Epoxy Caulk will fill voids at the nose of the step and give needed support underneath the Stair Tread nose. Treads will last much longer. Nose Caulk can also be used to repair the top surface of the step. Two-part mixture in quart units; mixing instructions on label. One properly mixed quart covers approx. 75 lin. ft. of 1/4" caulk beading.

NEW – Dual-Cartridge of two-part Epoxy Stair Nose Caulk for use with our professional Dual-Cartridge Dispenser. Caulk mixes in nozzle as caulk is dispensed. Saves time, labor, mess, stress and cleanup. One 13-1/2 oz. Dual Cartridge yields approx. 50 lin. ft. of 1/4" beading.