MBCI
14031 West Hardy
P.O. Box 38217
Houston, TX 77238
Tel: (877) 713-6224
Web site: http://www.mbci.com

FlexLoc®

The FlexLoc® panel system combines a clean, flat appearance with an easy-to-engage seam. This seam becomes even tighter as the up-lift pressure increases. Because of this feature, the FlexLoc® is an ideal system for curved applications as well as a soffit system.

CONCEALED FASTENING SYSTEM
The FlexLoc® system is attached to the substructure by concealed clips with a low profile pancake head fastener.

APPLICATION
FlexLoc® panels can be used for soffit systems or barrel vault roofs. On barrel vault roofs, FlexLoc® panels should be attached to a waterproofed, solid substructure. When used as a fascia, panels canbe applied to open framing such as the MBCI LiteFrame™ system.

ARCHITECT/ENGINEER INFORMATION

1. Use a properly aligned and uniform substructure to avoid panel distortion. Typical substructure for barrel roofs:  two layers of 3/8" plywood over metal deck. For fascia and soffit: subgirts or hat sections.
2. For barrel roofs, the panels must be installed over a completely waterproofed substructure. If the waterproofing membrane is mechanically attached with metal fasteners of any type, they should be covered to protect the back side of the panels. Any mechanical attachment device that does not lay flat on the deck will telegraph through the panels.
3. Panels are subject to surface distortion due to improperly applied fasteners. Overdriven fasteners will cause stress and induce oil canning across the panel at or near the point of attachment. Oil canning is not a cause for rejection.
4. For continuous panels over 40', please inquire.
5. Panels can be walked down to a 10'-0" minimum radius. Contact MBCI for radii of 10'-0" or less.

GENERAL DESCRIPTION

Coverage Width - 8 1/2", 9 1/2", or 10 1/2"
Panel Attachment - Clips
Panel Substrate - Galvalume
Gauge - Standard:  24        Optional:  22
Finishes - Smooth or Embossed
Coating - Signature® 200, Signature® 300 or Signature® 300 Metallic