Crane Composites, Inc. (formerly Kemlite Co.) 
Fiberglass Ceiling Grid System When Specs call for the best... Sanigrid is an all-fiberglass ceiling grid system known for its moisture and corrosion resistance in high humidity and chemical environment installations. It will not rust, pit, dent, or peel like metal grid systems. Sanigrid II is now easier to install, so it’s an even smarter choice for areas where sanitation is important. The new Sanigrid II system uses a series of pre-notched main tees and cross members to lock the grid together, eliminating the use of the time-consuming junction clips used with the original Sanigrid. The entire system snaps together quickly which reduces the high installation cost previously associated with frp grids. For the ultimate corrosion resistant ceiling grid system, use Sanigrid with Glasbord frp ceiling panels. These panels are engineered for lay-in ceiling applications to prevent sagging. Glasbord panels are the only frp panels with the exclusive Surfaseal finish. Won't rust, dent, chip, or peel
Sanigrid Uses and Applications
PART NAMES AND NUMBERS 1" x 1" (25.4 mm x 25.4 mm) wall angles come cut in standard 12' (3.7 m) lengths to fasten directly to the wall. MAIN RUNNER - #SG201 Main runners come in 12' 1½" (3.7 m) lengths. Notches for cross tee attachments and hanger wires are 6-1/16" (154 mm) on center. CROSS TEE - #SG202 (4'/1.2 m), #SG222 (2'/0.6 m), #SG223 (2'/0.6 m) Cross tees are available in 48½" (1232 mm) lengths, pre-notched to snap into the main runners, 24-1/8" (613 mm) lengths notched to nest with the 48½" (1232 mm) tees, and 24½" (622 mm) lengths to mate with the main runners. WALL ANCHOR CROSS TEE - #C-20 Wall anchors are available to secure the main runner and cross tees to the wall angle. Also available is industrial double-faced tape (part #T-30) that can be used in lieu of screws to attach the wall anchor. MAIN TEE SPLICE - #C-21 The Main tee splice is used to securely join two main runners. CEILING PANEL HOLD DOWN CLIP - #C-24, C-25 Two different hold down clips are offered to firmly secure the lay-in ceiling panels. Hold down clip C-24 is used for ceiling panels 3/32" (2.4 mm) to 9/32" (7.1 mm) thick. Hold down clip C-25 is for use with panels 9/32" (7.1 mm) to 1/2" (12.7mm) thick. Hold down clips are intended only to hold ceiling panels in position. They will not prevent panel warping under severe environmental conditions. RIVET - #R52503 (3/4"/19 mm), R52501 (1"/25.4 mm), R52502 (1.5"/38 mm), R52507 (2"/50.8 mm) Not included with other materials-must be purchased separately. Sanigrid II has not been tested for compliance with seismic ceiling grid requirements. |