Roof Products and Systems
484 North Thomas Drive
Bensenville, IL 60106
Toll Free: (800) 624-8642
Tel: (630) 595-7320
Toll Free Fax: 866-466-9335
Fax: (630) 766-5259
E-mail: info@rpscurbs.com
Web site: www.rpscurbs.com

RPS ROOF CURBS FOR ALL METAL ROOFING SYSTEMS

Custom fabricated to fit all panel configurations and required roof pitches. Custom sized to fit all manufacturers' skylights, HVAC units, powered roof exhausters, intake and relief vents, smoke hatches, flues or any other roof mounted equipment with a solid water-tight design. They provide uniform curb construction, method and quality that is simple to detail, requires minimal architectural supervision, is convenient to contractors and has a low known cost.

MODEL RC-7
FOR PANEL RIB PRE-ENGINEERED METAL BUILDING CURBS

FEATURES & BENEFITS

INTEGRAL WATER DIVERTER CRICKET
the sure way to promote positive water run off and to eliminate water ponding.

INSULATION
3 lb. density rigid fiberglass board… built-in where it can't be omitted… provides condensation free openings… has sound absorption qualities.

WELDED CORNERS
continuous water-tight welds… monolithic construction… designed to meet all weight requirements.

GALVALUME STEEL*
provides strength of galvanized steel with the maximum corrosion-resistance of aluminum.

OPTIONAL FEATURES
other heights… roof pitch requirements… built-in burglar bars…extended base plate for damper installation… liners… heavier gauge materials…aluminum construction… neoprene gaskets.

SPECIAL APPLICATIONS
refer to Profile #4 in this program

SPECIFICATIONS

Furnish and install Roof Products and Systems Roof Curbs at all roof openings as detailed on drawings. Prefabricated roof curbs shall be of box section design, constructed using minimum 18 gauge galvalume steel with continuous welded seams, (14 gauge for curbs supporting HVAC units or as required) with fully mitred and welded corners, integral water deflecting cricket and shall be insulated with 1-1/2" thick 3 lb. density rigid fiberglass board. Roof curbs shall be internally reinforced on any side longer than 3'0" and shall have factory installed integral base plate. Height to be 8" above the roof or as detailed. Roof Curbs shall be level at the top with pitch built-in. Burglar bars, other heights, roof pitch, liners and other options shall be furnished where detailed and/or specified in accordance with Roof Products and Systems Corporation details.

Prefabricated Roof Curbs shall be Model RC-7 manufactured by Roof Products and Systems Corp., Bensenville, IL. Contractor fabricated Roof Curbs will not be accepted.