EPIC METALS CORPORATION
Specialty Deck Systems are available from Epic Metals
to enhance the appearance and expand the purpose of a metal deck system. These
systems make it unnecessary for a designer to limit the form and function of a
building to whatever capabilities basic floor and roof decks possess. The information
below is intended to introduce you to Epic Specialty Deck Systems; and to challenge
you to incorporate into your next building a product that exceeds ordinary metal
deck systems. Please contact Epic Metals for additional information.
Epic has been a manufacturer of quality floor and roof deck products since 1968.
Today, our product line features Specialty Deck Systems including:
Dovetail shaped ribs set this deck section apart from
EPIC WIDECK® LONG-SPAN
SYSTEMS improvements are the first for long-span metal deck systems since this
type of construction was introduced in the 1950s.
EPIC METALS SUPER WIDECK®
provides the first steel roof and floor system to open the truss or girder spacing
in excess of 35 feet.
EPIC "ER2RA" ACOUSTIC Ceiling Roof Deck:
The ER2RA System consists of a dovetail ribbed profile which 1. provides
a flat ceiling surface. The dovetail rib is two inches deep with a one and one-half
inch wide flat top flange and a one-half inch opening on the exposed surface.
The upper flat flange of the dovetail configuration allows for the attachment
of upper roof members (gypsum board, insulation, roofing membranes) 2.
while concealing the fastener 3. penetration inside the dovetail.
The rigidity of the dovetail ribbed panel assures stiffness between the structural
supports and will accommodate spans to twelve feet. The thick three pound density
acoustical element, 4. with its continuous galvanized mesh 5. support,
achieves superb N.R.C. ratings without relying on components that are outside
the ER2RA system. The acoustical components are easily installed after the attachment
of the ER2RA profile to the supporting members. No worry about locating acoustical
standoffs. No stuffing of acoustical elements into fluted cells. The large flat
surfaces can accommodate all fastening requirements easily whether it be for uplift
The use of the ER2RA System provides an aesthetically pleasing plank-look acoustical
ceiling and structural roof panel in one. The field labor necessary to install
the ER2RA System is less than a cellular acoustical ceiling while providing the
Clean linear plank look
Superb N.R.C. value .95
Light weight system easily installed
Desirable appearance, low maintenance
Spans up to 12'-0", high diaphragm resistance
Also can be used as composite form for concrete floor above ceiling
EPIC hangers can be used with dovetail profile to support light loads
when used as a ceiling and, up to 1000 lb. when used in construction with concrete
See your EPIC METALS CORPORATION representative for
EPIC METALS CORPORATION
Eleven Talbot Avenue
Rankin, PA 15104
Tel: (412) 351-3913
Fax: (412) 351-2018
Web site: http://www.epicmetals.com