Special-Lite -Standard Aluminum Vision Lite Kits & Muntins

DOWNLOADS

Aluminum rectangular vision lites for 1-3/4” thick flush door. Aluminum can be anodized or painted. All have precision cut mitered corners to deliver a clean and tight installation.Designed for use on Special-Lite flush doors, but rectangular lite kits can be purchased for other manufacturers’ doors.


Category: 087100 | door hardware | finish trim...

MasterFormat: Doors and Frames | Door Louvers and Vision Lights | Hardware...



Special-Lite
860 S. Williams Street
Decatur, MI 49045
Tel: (800) 821-6531
Fax: (800) 423-7610

info@special-lite.com

https://special-lite.com/

Find a rep/distributor

Request More Info

DOWNLOADS

Related Products

Overview


Standard Aluminum Vision Lite Kits & Muntins

FL Series (5 unique aluminum vision lites)

Aluminum rectangular vision lites for 1-3/4” thick flush door. Aluminum can be anodized or painted. All have precision cut mitered corners to deliver a clean and tight installation.Designed for use on Special-Lite flush doors, but rectangular lite kits can be purchased for other manufacturers’ doors.

FL Standard

Vision lite kits have screw applied aluminum stops, and may be specified for ¼”, 3/8″ ½”, 1” or 1-1/8″ (6.4mm, 9.525mm, 13mm, 25mm or 28.575mm) glazing. Factory or field install glazing (glass, polycarbonate, or panels). We also offer a 9-lite unit by using this vision lite with surface applied muntins. Contact us for unique or custom sizes or shapes to brand your entrance.

FL Standard with MNT-3

FL Standard vision lite kit (see above) with ½” (13mm) wide surface muntin system. Insulated 1” (25mm) glass units with internal muntins available.

FL Standard with MNT-4

FL Standard vision lite kit (see above) with 1-1/4” (32mm) wide surface muntin system. Insulated 1” (25mm) glass units with internal muntins available.

Vision Lite Recommendations:
  • Consult factory if total vision lite area will exceed 50% of the foamed area of the door.
  • Avoid hardware conflicts by locating kits at least 8” (203mm) from top of door, 12” (305mm) from bottom of door, and 7” (178mm) from the sides of door.
  • Special hardware such as concealed vertical rods, require engineering review when cutout area is near latch stile.


See More